Datasheet4U Logo Datasheet4U.com

U642B - Interval- and Wipe/ Wash Wiper Control IC

General Description

As a convenience feature of the windshield wiper intermittent and wipe/wash operation are implemented in most of the automobiles.

The U642B is the low-cost solution for an accurate timing function control.

Wipe/wash mode has priority over interval mode.

Key Features

  • D Interval pause: 4 to 20 s D Afterwiping time: 2 to 20 s D Wiper motor’s park switch D Wipe/wash mode priority D One external capacitor, determines all time sequences D Relay driver with Z-diode D Interference protection according to VDE 0839 or ISO/TR 7637/1 D Load-dump protected Block Diagram VS 8 OUT 7 PARK 6 VRef Park switch comparator WASH 5 VRef Input comparator Load-dump comparator VRef Logic VRef Interval comparator Wipe / wash comparator A B C D E F 1 GND 2 INT 3 Ct 4 Rt.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
U642B Automotive Wipe/Wash or Interval Switch TEMIC Semiconductors
U6433B Flasher/ 18-m Shunt/ Frequency Doubling Disabling TEMIC Semiconductors
U644B Flasher/ 18-m Shunt/ Extremly Low Current Consumption TEMIC Semiconductors
U644B-FP Flasher/ 18-m Shunt/ Extremly Low Current Consumption TEMIC Semiconductors

Other Datasheets by Atmel (now Microchip Technology)

Part Number Description
U641B INTERVAL AND WIPE/WASH WIPER CONTROL IC
U643 Flasher/ 30-mohm Shunt
U6432B Low-power Flasher IC with 18-mOMShunt
U6433B Frequency Doubling Disabling
U643B Flasher IC

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
U642B Interval- and Wipe/ Wash Wiper Control IC Description As a convenience feature of the windshield wiper intermittent and wipe/wash operation are implemented in most of the automobiles. The U642B is the low-cost solution for an accurate timing function control. Wipe/wash mode has priority over interval mode. Interval pause and afterwiping time can be set to fixed values by using resistors in a broad time range. Added value can be provided with an individual, continuous adjustment of the interval pause by a potentiometer which may be built into the stalk. For proper operation it is mandatory to feed the signal of the wiper motor‘s park switch into U642B.