AT90RF135602 Datasheet | Atmel

Features - Contactless Interface - Reads and Writes Passive RFID Tags in the Unlicensed 13.56 MHz Band - Employs ISO/IEC14443 Type A Modulation Schemes - Autonomous Operation Capability (can scan and read tags without host intervention - i.e. only passes data following successful read/write operation) - patible with NFC Initiation Only Device - User Has Control Over Initiation of all RFID Based Services and Features - Read/write Operation Between 1 cm and 10 cm Read Range, Depending on Reader/Tag Antenna Coil Sizes and Orientation Relative to the Reader - Collision Detection as Standard - Transparent Modes for Software Controlled Modulation Supports Maximum Flexibility and Future Protocols - Fast Data munication Rate of 106 kbit/s - Suitable for Operation with a Wide Variety of Antenna Coil Sizes and Form Factors - Four Software Adjustable Carrier Field Drive Levels Controller and Software - On-board Powerful Atmel AVR® RISC microcontroler, programmed with Innovision® proprietary software. - Built in Self Test and Diagnostic Modes - Internal 8 MHz RC Oscillator for Micro or External Crystal Operation Host Interface - 3-wire SPI Interface as Standard - Full Software Control via SPI bus at 115 Kbaud as Standard Interface Power Supply - Ultra Low Current Operation and Stand-by Sleep Mode Typically < 1 µA - Ultra Low Voltage Operation: 2.7V - 3.3V Additional features - Packages: LBGA36 - LBGA Requires Only an External Crystal, 10 Passives and the Reader Antenna Coil - Operating temperature range: -30°C to +80°C - - - - Integrated 13.56 MHz Contactless Reader with Embeded software AT90RF135602 Description AT90RF135602 is an ultra small footprint low-cost Radio Frequency Identification (RFID) reader developed with Innovision Research & Technology plc to address multi-protocol 13.56 MHz RFID applications. It is optimised for use with the established ISO/IEC14443 type A standard and is available in Low-profile Ball Grid Array (LBGA). The LBGA incorporates a custom...