HFBR-707X2DEM Datasheet | AVAGO TECHNOLOGIES

Description The X2 LRM fiber optic transceiver is an “intelligent” optical module which incorporates the plete physical layer functionality of 10Gb E on multi mode fiber with data rate of 10.3Gbps. The X2 LRM module includes a transmitter that incorporates an uncooled, directly modulated 1.3 µm Fabry-Perot laser. The receiver subassembly includes a PIN photodiode and a linear/AGC trans-impedance amplifier. To cope with the effect of modal dispersion of multi mode fibers at 10 Gbps over the distances specified in the IEEE 802.3aq LRM standard, an electronic dispersion pensation circuit is used. The MUX/DEMUX, XAUI interface and MDIO management functions are all integrated into the module, as is a precision oscillator. The module is pliant to the X2 Multi Source Agreement specifications. Features - pliant with IEEE LRM Standard - Draft P802.3aq TM/D4.0 for Type 10GBASE-LRM - pliant with X2 MSA Issue 2.0b - Standard SC Duplex fiber optic connector - Standard 70 pin electrical connector - Four wide XAUI Electrical interface - MDIO Management Interface - Front Panel hot pluggable - Digital Optical Monitoring (DOM) provides Tx/Rx power, laser bias current, and module temperature Specifications - 220m reach on OM1, 0M2 and OM3 Multimode Fiber Cables - Total Power Dissipation less than 4W Applications - Ethernet switching systems - Ethernet peripheral interface - puter system I/O General Specifications .. Optics EDC 802.3ae Ser Des LD Micro I2C MDIO Other Signals Rx ROSA Optics Laser TOSA Tx System Control Figure 1. High level block diagram General Optical Specifications Optical Connector: SC Duplex Optical Line rate: 10.3125 Gb/s Link Length: 220m, with 62.5um MMF/ 160/500MHz- km 220m, with 50um MMF/ 500/500MHz- km 220m, with 50um MMF/ 1500/500MHz- km Laser: 1310nm FP Laser Detector: PIN diode General Electrical...