Advanced Analogic Technologies AAT4650
The AAT4650 SmartSwitch™ is a single channel PC Card (PCMCIA) power switch. It is used to select between two different voltage inputs, each between 2.7V and 5.5V. The device's output, VCC, is slew rate controlled and current limited, in compliance with PC Card specifications.| Part No. | AAT4650 |
|---|---|
| Datasheet | AAT4650 Download |
| Manufacturer |  Advanced Analogic Technologies |
| Description | 5V/3V PC Card Power Switch |
| Buy | Stock & Price |
GENERAL DESCRIPTION
An internal switch powers the circuitry from whichever input voltage is higher. The current limit response time to a short circuit is typically 1µs. The internal P-Channel MOSFET switches are configured to break before make, that is, both switches cannot be closed at the same time. Controlled by a 2 bit parallel interface, the four states for VCC are VCC5, VCC3, Hi-impedance, or Ground. When in the ground state, VCC is pulled to ground by a 5kΩ resistor. An open drain FAULT output is asserted during over-current conditions. During power up slewing, FAULT also signals that VCC is out of tolerance. An internal over temperature sensor forces VCC to a high impedance state when an over-temperature condition exists. Quiescent current is typically a low 15µA, as long as ICC is less than approximately 500mA. Above this load current, the quiescent current increases to 200µA. The AAT4650 is available in 8-pin SOP and TSSOP packages specified over -40 to 85°C.FEATURES
●●
●
●...
