AP1202 Datasheet PDF

Anachip AP1202

The AP1202 series are dual integrated high-side power switch with independent enable and flag functions, optimized for self-powered and bus-powered Universal Serial Bus (USB) applications. The AP1202 series support the following USB requirements: each switch channel supplies up to 500mA as required by USB downstream devices; the switch’s low on-resistance meets USB voltage drop requirements; fault current is limited to typically 650mA, well below the UL 25VA safety requirements; and a flag output is available to indicate fault conditions to the local USB controller.

Part No.	AP1202
Datasheet	AP1202 Download
Manufacturer	Anachip
Description	Dual USB High-Side Power Switch
Buy	Stock & Price

FEATURES

- Compliant to USB specifications - Dual independent switches control - 2.7V to 5.5V input voltage - 500mA minimum continuous current per port - 110mΩ typical on-resistance - 0.75A maximum short circuit current limit - Independent open-drain fault flag pins - 110μA typical on-state supply current - 1μA typical off-state supply current - Output can be forced higher than input (off-state) - Thermal shutdown - 2.4V typical under voltage lockout (UVLO) - 1ms turn-on (soft-start) and fast turn-off - Enable active-high (H) or active-low (L) - 8-pin SOP and PDIP packages

GENERAL DESCRIPTION

Soft start eliminates the momentary voltage drop on the upstream port that may occur when the switch is enabled in bus-powered applications. Additional features include thermal shutdown to prevent catastrophic switch failure from high-current loads, under voltage lockout (UVLO) to ensure that the device remains off unless there is a valid input voltage present, and 3.3V and 5V logic compatible enable inputs.