Atelic Systems AT2008
The AT2008 is an eight full-duplex channels ADPCM processor. It follows the G.726 ITU Standard for ADPCM compression for 40k, 32k, 24k and 16k bit rates with selectable µ-law and A-law input/output. This chip can operate on 16 channels of PCM to ADPCM compression, 16 channels of ADPCM to PCM decompression, 8 channels of full-duplex operation in an 8KHz frame basis, or any combination of M-channels of compression plus N-channels of decompression when M+N| Part No. | AT2008 |
|---|---|
| Datasheet | AT2008 Download |
| Manufacturer | Atelic Systems |
| Description | 8 Channel ADPCM Processor |
| Buy | Stock & Price |
DESCRIPTION
<= 16. Using the 3-wire command serial port, each individual half-channel can be dynamically configured to perform the ADPCM algorithm at different bit rates, idle or reset of the algorithm. It can also be programmed to set up different input/output time slots, or to select, (1) bypass without compression, (2) idle, or (3) reset of the algorithm.FEATURES
●●
●
●
●
●
●
●
● 8 full channels of ITU G.726 ADPCM ADPCM coding and decoding with bypass mode Per channel selectable µ-Law and A-law input/output Up to 8 synchronous signals for direct interface with popular combo/codec. On-chip time slot assignment Available internal clock generator and frame sync. generator Simple 3-wire serial command port for chip configuration On-chip power-up/power down/reset The two clock pins (CLKA and CLKP) used as PCM/ADPCM data clocks, and the FSY pin used for Frame Sync signals can be programmed to become either as input pins or as output pins. (The defaults are as input pins).
APPLICATIONS
●●
● DECT VoIP / VoDSL Wireless PBX systems Default Settings 3-wire serial command is required to configure the chip running ADPCM in 8 full channels.
