AP3860 Datasheet | BCD

Preliminary Datasheet Superior Multi-touch Capacitive Touch Screen Controller AP386X General Description The AP386X is a low-cost high-resolution single chip solution for APA (All point addressable) capacitive touch screen. It is an 8-bit single cycle 8051 microcontroller with ICP Interface. The chip includes 12-bit successive approximation analog-to-digital converters with an I2C interface and multiplexer-switcher circuits for flexible measurement of analog signal from APA panel. An accurate switched-capacitor integrator is built-in and it can auto calibrate the pixel parameters for a wide range of capacitance on the touch screen (1p F to 32p F). This touch screen controller (TSC) with CMOS integration circuit provides an ideal choice for APA touch panel. The AP386X is specified over the temperature range of -40°C to 85°C. The AP386X is available in QFN-5×5-40 (for AP3860) and QFN-6×6-48 (for AP3861) packages. Features - Mutual Capacitive Touch Sensing - Single Power Supply: 2.8V to 3.6V Operation Voltage; LDO inside to Support 1.6V to 2.0V Operation Voltage - Up to 17/23 Drive Lines and 10/12 Sense Lines - Charge Pump Support up to 6V, Doubling SNR - Internal Two-wire Serial Control Bus I2C - Single-end Integrator with Programmable Gain Control - Multiplexed Analog Digitization with 12-bit Resolution Scan SAR ADCs and Its Dedicated 2X to 8X Accumulator XSRAM Buffers Features (Continued) - Single Cycle 8051 CPU Core, Maximum Operating Clock up to 28MHz from IOSC (Zero Wait State) 4 to 28MHz Internal Oscillator (IOSC) 32k-byte Flash ROM 6k-byte Internal SRAM Two 16-bit Timers T0/T1 Configurable I2C Slave Controller and SPI Slave Controller Shared with the Same Ports - With Asynchronous I2C Slave Address Detection Logic Design 4 General Purpose GPIO Pins One External Interrupt Pin - ISP/IAP via I²C Port - Operation Temperature Range: -40°C to 85°C - Package Type Alternatives: QFN-5×5-40 and QFN-6×6-48 - Ro HS pliance - Operating Mode: Mode Power-down...