MPD-830R Datasheet | BOSER Technology

Industrial Power Supply 300W DC-DC ATX Power Supply DC-DC DC INPUT CABLE 30.0 12.0 0.3 1.0 0.3 3.0 0.4 DC OUTPUT WIRES 13.0 1.0 0.47 12.5 13.8 Output Min. Voltage Load +5V 2A +12V 0.1A -12V 0A -5V 0A +3.3V 0A +5Vsb 0A Rated Load 25A 10A 1A 1A 8A 0.72A Max. Load 30A 15A 2A 2A 15A 1.2A Voltage Accuracy 4.8~5.2V 11.4~12.6V -11.4~-12.6V -4.75~-5.25V 3.13~3.4V 4.75~5.25V Specifications Input Voltage The range of input voltage is from 72~136VDC Input Current The maximum input current is 5A at 110VDC input Inrush Current Will not exceed 10A at 110VDC input cold start, 25o C Load Range At factory, all outputs in 60% rated load condition; the +5V output is set to between 4.80V and 5.20V. The other outputs are checked to be within the specified voltage accuracy range Ripple And Noise The peak to peak ripple and noise for +5V, +3.3V outputs are less than 50m V, and for the other output are less than 100m V at rated load. Measuring is done by 15MHz bandwidth limited oscilloscope and terminated each output with a 0.47u F capacitor electrolysis capacitor at rated load, nominal line Line Regulation The output line regulation for each output is less than +/-1% while measuring at rated load and -40~-72VDC input voltage changing Load Regulation The output voltage load regulation is less than the values in the following table by changing each output load +/-40% from 60% from rated load, and keep other outputs at 60% rated load Output Power The total DC continuous power shall be kept within 300W ambient temperature of 40o C below, and input voltage at 110VDC. The maximum, total bined output power on the 3.3V and 5V rails is 150W Power On Signal .. This TTL patible signal (active low) is use to switch ON the main output. When power on is disconnected from secondary mon, all outputs except +5Vsb shall turn off Power Good Signal When power start-up, the power good signal will increase between 100ms to 500ms after all...