MPE-825A
MPE-825A is 280W AC-DC ATX Power Supply manufactured by BOSER Technology.
Features
4.8 0.5 11.5
- Input Voltage: 90~130VAC or 180~260VAC, auto switchable
- Input Frequency: 47~63Hz
- Inrush Current: Does not exceed 40A at 115VAC input or
- Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950 80A at 230VAC input, at cold start 25o C
- EMI: FCC class B / EN55022B
- Ripple And Noise: Peak to peak ripple and noise for each
- EMS: Level 3 of IEC-801, 802, 803, 804 output is < 1% of each output voltage at rated load 115~230VAC
- Line Regulation: < +/-1% at rated load with +/-10% change in input voltage Output PIN
- Load Regulation: The output voltage load regulation is less +5V Red GND Yellow than the values on the table when each output loading changes Brown +12V +/-40% from 60% rated load while all other outputs at 60% Grey -12V rated load Black +5V
- Hold Up Time: > 20ms at 115VAC input and rated load White GND measured from the end of the last charging pulse to when the Orange +12V main output drops down to 95% output voltage Purple -12V
- Power Good Signal: Goes high 100~500ms after all DC Green PWR On output are ready
- Power Failure: Goes low 0.5ms before any DC output falls Output Min. Rated Max. Tolerance
- Power On: TTL patible signal (active low) used to switch Voltage Load Load Load ON the main output. When power on is disconnected from +/-0.2V 0A 25A 30A +5V secondary mon, all outputs except +5Vsb are turned off 10A 15A +/-0.24V +12V 0.1A
- Efficiency: > 65% at nominal line and rated load +/-0.6V -12V 0A 0.5A 1A
- Altitude: 10,000 feet +/-0.25V -5V 0A 0.5A 1A
- Protection: 15A +/-0.17V +3.3V 0A 8A Short Circuit: Hiccup mode function against short circuit or +5Vsb 0A 0.72A 1.5A +/-0.25V over load conditions auto restarts when fault conditions are removed Output: Built-in crowbar circuit automatically shuts down outputs to avoid damaging external circuits. Trip point of .. O.V.P. circuit is between 5.7~7.0V
- Temperature: 0~70o C (operating); -40~+75o C (storage)
- Humidity: 5~95%; non-condensing at 40o C (operating)
- Connectors: AC Input/Output: Meets IEC...
