MHP50 Datasheet | Bi technologies

50W TO220 High Power Resistors MHP 50 - Non-inductive, thin film technology. - Thermally enhanced Industry standard TO220 package. - Ro HS pliant. - Low thermal resistance, 2.3 °C/W resistor hot spot to metal tab. - plete thermal flow design available for easy implementation. - Superior vibration durability. - Small thin package for high density PCB installation. - High frequency circuits and wide band / linear amplifiers. - Switch mode and industrial RF power sources. - AC motor control, electronic load and drive circuits. - Automotive. - Industrial PC modules (IPM) and measurement systems. Specifications Items Power Rating Power Rating Thermal Resistance Resistance Range Nominal Resistance Series TCR Tolerance Operating Temp. Range Max. Operating Voltage. Dielectric Withstand Voltage Load Life Temp. Cycle Humidity Soldering Heat (Max) Solderability Insulation Resistance Vibration 0.01-0.09 Ω E6 250 ppm/°C +/-5% Specification 50 Watts 1 Watts 2.3°C/W 0.1-9.1 Ω E24 100 ppm/°C +/- 5% and 1% -55 to +155 °C 500V or √ P.R 2000 Volts DC ΔR +/- (1.0 %+0.05 Ω) ΔR +/- (0.25 %+0.05 Ω) ΔR +/- (1.0 %+0.05 Ω) ΔR +/- (1.0 %+0.05 Ω) Min 95% coverage Over 1000 MΩ ΔR +/- (0.25 % Ω) 60 seconds. between terminals and flange 25°C, 90 min. ON, 30 min.OFF, 1000 hours. -55 °C,30 min.,+155 °C,30 min., 5 cycles 40°C, 90-95% RH, DC 0.1W, 1000 hours. 250+/-5°C, 3 seconds, 230+/-5°C, 3 seconds. Between terminals and metal back plate. 10-220 Ω E24 50 ppm/°C +/- 1% Conditions @ Tab Temp < 25°C Free air. From hot spot to tab. Extended resistance range to 51KΩ available Additional 2.0Ω and 5.0 Ω also avail available For -55 to +155°C Applications Note: 1. For resistances from 220 to 51k Ω the power rating shall be restricted to 30W. General Note TT electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT electronics’ own data and is considered accurate at time of going to print. .bitechnologies....