Datasheet4U Logo Datasheet4U.com

CS3750 - 100mA Dual H-Bridge Air-Core Gauge Driver

General Description

The CS3750 is a dual H-bridge four quadrant air-core gauge driver.

The IC provides all the functions necessary to drive a tachometer or speedometer as part of a microprocessor based multiplexed system.

Digital input control eliminates the need for any analog calibration of the gauge.

Key Features

  • s 2 Independent NPN H-Bridge Drivers s No Analog Trim Required s Used in Multiplexed Systems s Quiet Gauge Operation s Programmable Slew Rate Minimizes Switching Noise s Fault Protection Over Voltage Thermal Shutdown Short Circuit Absolute Maximum Ratings Supply Voltage 7.5V to +16V Internal Power DissipationInternally limited Logic Input Voltages Ð0.3V to 6.5V Junction Temperature Range Ð40¡C to +150¡C Storage Temperature Range Ð55¡C to +165¡C Lead Temperature Soldering Wave Solder (through ho.

📥 Download Datasheet

Datasheet Details

Part number CS3750
Manufacturer Cherry Semiconductor Corporation
File Size 137.38 KB
Description 100mA Dual H-Bridge Air-Core Gauge Driver
Datasheet download datasheet CS3750 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
CS3710B8 Silicon N-Channel Power MOSFET Huajing Microelectronics
CS37N06AQ4-G Silicon N-Channel Power MOSFET CR Micro
CS3-PI-S774 ADS TFT-LCD Module BOE
CS30-10N-1 PROXIMITY SWITCH HIGHLY
CS30-10N-2 PROXIMITY SWITCH HIGHLY

Other Datasheets by Cherry Semiconductor Corporation

Part Number Description
CS3706 Dual Output Driver
CS3717A 1A H-Bridge Stepper Motor Driver
CS3720 2A H-Bridge Driver
CS3341 Alternator Voltage Regulator Darlington Driver
CS3351 Alternator Voltage Regulator Darlington Driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
CS3750 CS3750 100mA Dual H-Bridge Air-Core Gauge Driver Description The CS3750 is a dual H-bridge four quadrant air-core gauge driver. The IC provides all the functions necessary to drive a tachometer or speedometer as part of a microprocessor based multiplexed system. Digital input control eliminates the need for any analog calibration of the gauge. The controlling microprocessor sends out a PWM signal to each H bridge driver input (IN1, IN2). The PWM signal duty cycle is proportional to the HÐbridge output. Output current (100mA max) direction is controlled by the DIRECTION input. PWM switching noise is minimized at each half bridge by an internal RC filter and external programmable capacitor.