HTV546AG Datasheet | Connor-Winfield Corporation

SCRIPTION OPERATING SPECIFIC ATIONS PARAMETER Frequency Range Frequency Calibration @ 25°C Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Jitter (BW=10Hz to 20MHz) Jitter (BW=12k Hz to 20MHz) Typical Phase Noise Measurements @ 19.44 MHz SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset (Vcc) (Icc) The Connor-Winfield HTV546AG is a 14 pin DIP, 5.0V HCMOS, Voltage Controlled Temperature pensated Crystal Oscillator (VCTCXO). The HTV546AG is designed for use as a SONET/SDH Network Timing Source. INPUT CHARACTERISTICS PARAMETER Control Voltage Frequency Adjust Range (0.5 to 4.5V) Frequency Adjust Linearity Input Impedance (Vc) MINIMUM 0.5 ±10 -10 10k NOMINAL 2.5 MAXIMUM 4.5 ±25 10 UNITS Vdc ppm % Ohm Features 5.0V OPERATION LOW JITTER <1ps RMS TABLE 4.0 NOTE HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% MINIMUM 3.75 -8 45 NOMINAL MAXIMUM 15 0.5 8 55 5 UNITS p F Vdc Vdc m A m A % n S OVERALL FREQUENCY TOLERANCE ±4.6ppm TEMPERATURE RANGE: 0 to 70°C HERMETICALLY SEALED DIP PACKAGE Ro HS PLIANT / LEAD FREE (Voh) (Vol) (Ioh) (Ioh) 50 3 PACKAG E CHARACTERISTICS Package Hermetically sealed, metal package. ORDERING INFORMATION TABLE 5.0 Note: 1) Frequency calibration at 25°C, Vc=2.5V, nominal Vcc, after a one minute warm up time. 2) Inclusive of calibration, frequenc y vs. temperature stability, suppl y voltage change, load change, shock and vibration, 10 years aging. 3) Positive Slope. DATA SHEET #: Tx160 PAGE 1 OF 2 REV: 03 DATE: 09/07/06 - 100 MHz TCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. a Copyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 PREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. .. .CONWIN. PRODUCT D ATA SHEET Pin...