DS1413 Datasheet | Dallas Semiconductor

FEATURES - Small size, low-cost interface to an RS232C Port for reading and writing i Button devices - Supports reading all and writing non EPROM i Button devices at regular speed - Powered entirely from an RS232 interface .. - Standard DB female connector for mating to the Port of a puter with a DS9098 i Button Retainer for a single i Button or Micro LAN Cable (DS1402x) ORDERING INFORMATION DS1413 DB- 9 Connector DESCRIPTION The DS1413 Passive Serial Port i Button Holder is a simple, lowcost adapter which performs RS232C (±12V) level conversion, allowing a non-EPROM i Button to be read and written directly. It can also read all EPROM based i Buttons. The serial port must support a data transmission rate of 115.2 kbits/s in order to create the 1-Wire time slots correctly. Nearly all PCs and several other hardware platforms support the required bit rate and are fully patible with the DS1413. Since an eight bit character (6 data bits plus start-and stop bit) on the RS232C port operating at 115.2 kbits/s is used to form a single 1-Wire time slot, the maximum effective 1-Wire transfer rate is 14.4 kbits/s (regular speed). The DS1413 has a DS9098 retainer for a single F5 Micro-Can and can replace the DS9097 Port Adapter in applications that use only a single i Button. Multiple i Buttons can be connected to the DS1413 using standard Micro LAN Cables and button holders (see DS1401 and DS1402x data sheets). The DS1413 does not support the strong pullup which is required to run the Crypto i Button. For applications requiring a strong 5V pullup see DS1411. Details on the operation of the DS1413 are found in Application Note 74, Section V. 1 of...