DS9098P Datasheet | Dallas Semiconductor

FEATURES pact receptacle for F5 i Button mounting Fully backward-patible to DS9098 Contacts are stainless steel with selective tinlead plating for optimal solderability to printed circuit board Retainer to i Button connection is stainless steel to stainless steel Withstands up to 250°C for surface mounting Double redundancy of contacts (2 plus 2) Contact force exceeds 200 grams for reliable connection Prevents reversed insertion At insertion, the i Button is latched for retention The i Button pops up for removal when latch is released Gentle deflection of latches allows removal of the i Button >25 insertion/withdrawal cycles with no performance degradation patible with standard pick and place equipment Cleaning fluids drain freely for quick clean up 3-D View 39° 39° Top View Latch 14.35 2.60 13.00 17.60 ∅ 16.50 ∅ 19.50 3.40 4.40 Bottom View Side View Remended Printed Circuit Layout Pads Data Trace 8.5 Copper cladding ≥ 0.3 kg/m2 or ≥ 34 µm (≥ 1oz/sq.ft) with soldermask overlay Ø18.3 Ø13.7 ORDERING INFORMATION DS9098P-TRL Tape & Reel, 220 parts per 13 inch reel Ø10.8 Center - Data Outer Ring - Ground All dimensions are in millimeters. DESCRIPTION The DS9098P i Button Retainer is a low-cost, surface-mount device to secure an F5 i Button on a printed circuit board. It consists of three metal pieces (two for GROUND, one for DATA) molded into a body of black, heat-stabilized, 30% glass fiber reinforced Nylon 46. When inserting an i Button into the DS9098P, closely align axis of the i Button and the retainer. The retainer then latches the flange of the i Button. At removal, limit deflection of retainer latches to just free the i Button edge from retained state. Avoid applying excess force to latches. The DS9098P is only available on tape & reel. The tape specifications match those of 68-lead PLCC devices except for the deeper pockets and tape-feed sprockets on either side of the 44 mm tape. Alignment pedestals keep the part oriented on tape with the...