E13C7 Datasheet | ECLIPTEK

.. E13C7 Series - Ro HS pliant (Pb-Free) - LVPECL Output Oscillators - 3.3V Supply Voltage - Ceramic 6-pad SMD Package - Stability to ±25ppm - Tri-State Output - plementary Output - Available on Tape and Reel - Wide Range of Available Frequencies 2.0 7.0 5.0 OSCILLATOR ELECTRICAL SPECIFICATIONS Nominal Frequency (MHz) 77.760M, 78.125M, 80M, 80.157M, 85M, 87.125M, 90M, 100M, 106.25M, 110M, 119M, 120M, 122.888M, 124.4M, 125M, 127M, 128M, 133M, 133.333M, 137.472M,150M, 155.52M, 156.25M, 159.375M, 161.1328M, 162.5M, 166M, 170M, 175M, 176.83816M, 187.5M, 187.509375M, 200M, or 212.5MHz Operating Temperature Range Storage Temperature Range Supply Voltage (VCC) Input Current Frequency Tolerance / Stability 0°C to 70°C, or -40°C to +85°C -55°C to 125°C 3.3VDC ±5% 75m A Maximum ±100ppm, ±50ppm, or ±25ppm Maximum Output Voltage Logic High (VOH) Output Voltage Logic Low (VOL) Rise Time / Fall Time Duty Cycle Load Drive Capability Logic Control / Additional Output VIH of 70% of VCC Minimum Tri-State Input Voltage No Connection VIL of 30% of VCC Maximum Without Load Standby Current Start Up Time RMS Phase Jitter Typical Phase Noise FJ = 12k Hz to 20MHz Fo=156.250MHz Inclusive of All Conditions: Calibration Tolerance at 25°C, Frequency Stability over the Operating Temperature Range, Supply Voltage Change, Output Load Change, 1st Year Aging at 25°C, Shock, and Vibration 0°C to 85°C -40°C to 0°C 0°C to 85°C -40°C to 0°C 20% to 80% of waveform at 50% of waveform VCC-1.025VDC Minimum VCC-1.085VDC Minimum VCC-1.620VDC Maximum VCC-1.555VDC Maximum 300p Sec Typical, 700p Sec Maximum 50 ±5(%) 50 Ohms into VCC-2.0VDC Tri-State and plementary Output Enables Output Enables Output Disables Output: High Impedance 30µA Maximum 10 m Seconds Maximum 0.4p Sec Typical, 1 p Sec Maximum -60d Bc/Hz at 10Hz Offset -95d Bc/Hz at 100Hz Offset -125d Bc/Hz at 1k Hz Offset -143d Bc/Hz at 10k Hz Offset -145d Bc/Hz at 100k Hz Offset -145d Bc/Hz at 1MHz Offset -146d Bc/Hz at...