ELM411 Datasheet PDF (Debounce Circuit)

ELM411 - Debounce Circuit

Description

The ELM411 provides all of the necessary circuitry to connect as many as three independent mechanical contacts to an electronic circuit.

All mechanical contacts, whether from switches, relays, etc.

will have inherent ‘bounce’ when they make or break a connection.

Features

Low power CMOS design - typically 1mA at 5V Wide supply range - 3.0 to 5.5 volt operation Simultaneous monitoring of three circuits Full 25msec debounce period on contact closure and opening, without external components.
Internal pullup resistors for contact monitoring.
High current drive outputs - up to 25 mA.
Can be cascaded to provide sequential outputs Connection Diagram PDIP and SOIC (top view) VDD Out1 1 2 3 4 8 7 6 5.

Datasheet Details

Part number	ELM411
Manufacturer	ELM
File Size	41.17 KB
Description	Debounce Circuit
Datasheet	ELM411 Datasheet
Additional preview pages of the ELM411 datasheet.

📁 Similar Datasheet

ELM452 - TRANSISTOR PHOTOCOUPLER (Everlight)

ELM453 - TRANSISTOR PHOTOCOUPLER (Everlight)

ELM-1081SURWA - Dot Matrix Display (Everlight)

ELM-2001EWA - Dot Matrix Display (Everlight Electronics)

ELM-2001GWA - Dot Matrix Display (Everlight Electronics)

ELM-2001SRWA - Dot Matrix Display (Everlight Electronics)

ELM-2002EWA - Dot Matrix Display (Everlight Electronics)

ELM-2002GWA - Dot Matrix Display (Everlight Electronics)

ELM-2002SRWA - Dot Matrix Display (Everlight Electronics)

ELM-2081SURWA - Dot Matrix Display (Everlight)

Full PDF Text Transcription

Click to expand full text

ELM411 Debounce Circuit with Latch Description The ELM411 provides all of the necessary circuitry to connect as many as three independent mechanical contacts to an electronic circuit. All mechanical contacts, whether from switches, relays, etc. will have inherent ‘bounce’ when they make or break a connection. Depending on the type of switch, this fluctuation can be quite pronounced, often being interpreted as multiple inputs by high speed digital circuits. All of the logic required to remove the bounce from most mechanical sources is provided by this circuit, without the use of additional components. As well, internal pull-up resistors have been provided so that the switch inputs can be directly connected to the 8 pin package.

Published: Dec 20, 2013 |