K8006 Datasheet | Unknown Manufacturer

Features : SYSTEM Create your own domestic modular light control system For use with optional plug-in dimmer module (K8007) and plug-in timer module (K8008) þ Bus system holds up to five plug-in units þ Optically insulated push button inputs þ Can be controlled with open collector circuits (ex. K8000 puter inter face card or with IR remote control receiver K6711) þ Local control pushbuttons included þ LED power and mains indicator þ LED operation indicator for each channel þ Low-voltage control circuit for extra safety þ Each plug-in slot is fused þ Includes 10 LED’s for pushbutton illumination .. þ A custom enclosure for rail mounting is available (B8006) þ þ þ þ þ þ þ þ þ Specifications : Five separate channels Maximum output : 2.5A per channel (fuse protected) Push button control current: 150m A Open collector control current: 35m A DC Power supply: 24VAC / 300m A Supply voltage for modules: 110V to 240VAC PCB dimensions: 107 x 160 x 70mm/ 4.2”x6.3”x2.8” modifications reserved ILLUSTRATED ASSEMBLY MANUAL H8006IP-ED2 VELLEMAN PONENTS Legen Heirweg 33 9890 Gavere Belgium http://.velleman.be Assembly hints 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project successful. Read them carefully. 1.1 Make sure you have the right tools: - A good quality soldering iron (25-40W) with a small tip. - Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look. This is called ‘thinning’ and will protect the tip, and enables you to make good connections. When solder rolls off the tip, it needs cleaning. - Thin raisin-core solder. Do not use any flux or grease. - A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they cannot fly towards the eyes. - Needle nose pliers, for bending leads, or to hold ponents in place. - Small blade and phillips screwdrivers. A basic range is fine. For some...