EMW38GT Datasheet | EUROQUARTZ limited

EURO QUARTZ CMOS 14 pin DIL patible, 'W' Group Through-hole package patible with 14 pin DIL Frequency range: 200.01MHz to 800.0MHz Supply voltage 3.3 Volts Frequency stability from ±1ppm over -30 to +75°C Ro HS pliant DESCRIPTION EMW38GT series TCXOs are packaged in a through-hole package, pin patible with 14 pin DIL with trimmer. With squarewave (CMOS) output, tolerances are available from ±1.0ppm over -30° to +75°C. The part has a 0.01m F decoupling capacitor built in. SPECIFICATION Product Series Code TCXO: VCTCXO: Frequency Range: Output Waveform: Initial Calibration Tolerance: Standard Frequencies: EMW38GT VEMW38GT 200.01MHz to 800.0MHz Squarewave, HCMOS <±2.0ppm at +25°±2°C 200.0, 204.8, 311.04, 400.0, 409.6 and 622.08MHz (Partial list) ±3ppm minimum (see table) (see table) ±1.0 ppm max. first year ±0.3 ppm max. ±5% change ±0.3 ppm max. ±10% change ±1.0ppm max. for one reflow (Measured after 24 hours) +3.3 Volts Logic High: 90% Vdd min. Logic Low: 10% Vdd max. 65m A max. (Freq. dependant) 1.2ns typical 50%±5% 5ms typical, 10ms max. See table below 15p F -55~+125°C EMW38GT TCXO 200.0MHz to 800.0MHz - OUTLINES AND DIMENSIONS Mechanical Frequency Tuning: Operating Temperature Range: Frequency Stability vs. Ageing: vs. Voltage Change: vs. Load Change: vs. Reflow (SMD type): Supply Voltage: Output Logic Levels: Current Consumption: Rise and Fall Times: Duty Cycle: Start-up Time: Current Consumption: Output Load: Storage Temperature: VEMW38GT VOLTAGE CONTROL SPECIFICATION Control Voltage: Standard = +1.5±1.0Volts for all input voltages. (Contact technical sales if +2.5±2.0 Volts is required.) Frequency Deviation: ±6.0 ppm min. (Vcon = +4.5V±1.0V) Slope Polarity: Positive (increase of control voltage increases output frequency.) Input Impedance: 2M minimum Modulation Bandwidth: 25k Hz minimum Linearity: ±10% maximum SSB PHASE NOISE at 25°C Offset 10Hz -50 100Hz -77 1k Hz -102 10k Hz -115 100k Hz -108 FREQUENCY STABILITY Stability (ppm) 0 ~ +50 -10...