EBE51RC4AAFA Datasheet | Elpida Memory

PRELIMINARY DATA SHEET .. 512MB Registered DDR2 SDRAM DIMM EBE51RC4AAFA (64M words × 72 bits, 1 Rank) Description The EBE51RC4AAFA is a 64M words × 72 bits, 1 rank DDR2 SDRAM Module, mounting 18 pieces of DDR2 SDRAM sealed in FBGA package. Read and write operations are performed at the cross points of the CK and the /CK. This high-speed data transfer is realized by the 4bits prefetch-pipelined architecture. Data strobe (DQS and /DQS) both for read and write are available for high speed and reliable data bus design. By setting extended mode register, the on-chip Delay Locked Loop (DLL) can be set enable or disable. This module provides high density mounting without utilizing surface mount technology. Decoupling capacitors are mounted beside each FBGA on the module board. Note: Do not push the ponents or drop the modules in order to avoid mechanical defects, which may result in electrical defects. Features - 240-pin socket type dual in line memory module (DIMM)  PCB height: 30.0mm  Lead pitch: 1.0mm  Lead-free - 1.8V power supply - Data rate: 533Mbps/400Mbps (max.) - 1.8 V (SSTL_18 patible) I/O - Double-data-rate architecture: two data transfers per clock cycle - Bi-directional, data strobe (DQS and /DQS) is transmitted /received with data, to be used in capturing data at the receiver - DQS is edge aligned with data for READs; center aligned with data for WRITEs - Differential clock inputs (CK and /CK) - DLL aligns DQ and DQS transitions with CK transitions - mands entered on each positive CK edge; data referenced to both edges of DQS - Four internal banks for concurrent operation (ponent) - Burst length: 4, 8 - /CAS latency (CL): 3, 4, 5 - Auto precharge option for each burst access - Auto refresh and self refresh modes - 7.8µs average periodic refresh interval - Posted CAS by programmable additive latency for better mand and data bus efficiency - Off-Chip-Driver Impedance Adjustment and On-Die Termination for better signal...