NTQ165 Datasheet | Emerson

50-165 Watts NTQ160 Series Total Power: 50-165 Watts Input Voltage: 85-264 VAC # of Outputs: Quad Electrical Specs Input Input range Frequency Inrush current Efficiency EMI filter 85-264 VAC 47-63 Hz 38 A max., cold start @ 25°C 65% typical at full load @ 115 VAC input FCC Class B conducted and radiated, CISPR 22 Class B conducted and radiated, EN55022 Class B conducted and radiated, VDE 0878 PT3 Class B conducted and radiated. 0.99 typical <1 m A @ 50/60 Hz, 264 VAC input Power factor Safety ground leakage current Special Features - Active power factor correction - EN61000-3-2 pliance - Remote sense on outputs one and two - Power fail and remote inhibit - 5V Standby output - DC Power good - Single wire current sharing on outputs one and two - Wide range adjustable on outputs 1 & 2 - Built-in Class B EMI filter - Overvoltage protection - Overload protection - Thermal overload protection - Outputs 3 & 4 are floating Output Maximum power Adjustment range Hold-up time Overload protection 50W convection, 165 W with 30 CFM forced air 1.8V - 3.5V; 3.0V - 5.5V on outputs one and two 20 ms @ 165 W load Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating. Latching type recycle AC to reset. Tracks outputs 1 & 2: 20% to 35% above output setting 5V@ 2 A regulated ±5% Overvoltage protection Standby output Logic Control Power failure Remote Inhibit Remote sense TTL logic signal goes high 100-500 msec after V1 output; it goes low at least 4 msec before loss of regulation Requires contact closure to inhibit outputs pensates for 0.5 V lead drop minimum, will operate without remote sense connected. Reverse connection protection. TTL logic signal goes high after main output is in regulation. It goes low when there is a loss of regulation. Environmental Operating temperature: 0° to 50°C ambient; derate each output at 2.5% per degree from 50° to 70°C Electromagnetic susceptibility: Designed to meet EN61000-4, -2, -3, -4, -5, -6,...