• Part: EN25Q80A
  • Description: 8 Megabit Serial Flash Memory
  • Manufacturer: Elite Semiconductor Microelectronics Technology
  • Size: 1.06 MB
Download EN25Q80A Datasheet PDF
Elite Semiconductor Microelectronics Technology
EN25Q80A
EN25Q80A is 8 Megabit Serial Flash Memory manufactured by Elite Semiconductor Microelectronics Technology.
FEATURES - Single power supply operation - Full voltage range: 2.7-3.6 volt - Serial Interface Architecture - SPI patible: Mode 0 and Mode 3 - 8 M-bit Serial Flash - 8 M-bit/1024 K-byte/4096 pages - 256 bytes per programmable page - - Standard, Dual or Quad SPI Standard SPI: CLK, CS#, DI, DO, WP# Dual SPI: CLK, CS#, DQ0, DQ1, WP# Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3 High performance 100MHz clock rate for one data bit 80MHz clock rate for two data bits 80MHz clock rate for four data bits - Software and Hardware Write Protection: - Write Protect all or portion of memory via software - Enable/Disable protection with WP# pin - High performance program/erase speed Page program time: 1.3ms typical Sector erase time: 90ms typical Block erase time 500ms typical Chip erase time: 8 seconds typical - Lockable 256 byte OTP security sector - Minimum 100K endurance cycle - Package Options 8 pins SOP 150mil body width 8 pins SOP 200mil body width 8 contact VDFN 8 pins PDIP All Pb-free packages are Ro HS pliant - Low power consumption - 12 m A typical active current - 1 μA typical power down current - Uniform Sector Architecture: 256 sectors of 4-Kbyte 16 blocks of 64-Kbyte Any sector or block can be erased individually - Industrial temperature Range GENERAL DESCRIPTION The EN25Q80A is an 8 Megabit (1024K-byte) Serial Flash memory, with advanced write protection mechanisms. The EN25Q80A supports the standard Serial Peripheral Interface (SPI), and a high performance Dual output as well as Quad I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI), DQ1(DO), DQ2(WP#) and DQ3(NC). SPI clock frequencies of up to 80MHz are supported allowing equivalent clock rates of 160MHz for Dual Output and 320MHz for Quad Output when using the Dual/Quad Output Fast Read instructions. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. The EN25Q80A is designed to allow either single Sector/Block at a time or full chip erase operation. The EN25Q80A...