FT311D
FT311D is USB Android Host manufactured by FTDI.
features
:
- Single chip USB to selectable interface.
- Entire USB protocol handled on the chip. No USB specific firmware programming required.
- Interface options selectable via 3 mode select
- pins.
- 7 GPIO lines interface option
- Basic UART interface with RXD, TXD, RTS, CTS pins option.
- - TX_ACTIVE signal for controlling transceivers on RS485 interfaces.
- - 4 PWM channels option.
- - I2C master interface option.
- - SPI Slave interface option supporting modes 0,
1, 2 and 3 with MSB/LSB options
- - SPI Master interface option supporting modes
0, 1, 2 and 3 with MSB/LSB options.
- - USB error indicator pin
Suitable for use on any Android platform supporting Android Open Accessory Mode (Typically 3.1 onwards, however some platforms may port Open Accessory Mode to version 2.3.4)
12MHz oscillator using external crystal.
Integrated power-on-reset circuit.
+3V3 Single Supply Operation with 5V tolerant inputs.
USB 2.0 Full Speed patible.
Extended operating temperature range; -40⁰C to 85⁰C.
Available in pact Pb-free 32 Pin LQFP and QFN packages (both Ro HS pliant).
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or fa ilure of this product. Your statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary information that may be subject to change without notice. No freedom to use patents or other...
