Datasheet4U Logo Datasheet4U.com

FST3306 - 2-Bit Low Power Bus Switch

General Description

The FST3306 is a 2-bit ultra high-speed CMOS FET bus switch with TTL-compatible active LOW control inputs.

The low on resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise.

Key Features

  • s Typical 3Ω switch resistance at 5.0V VCC s Minimal propagation delay through the switch s Power down high impedance input/output s Zero bounce in flow through mode. s TTL compatible active LOW control inputs s Control inputs are overvoltage tolerant Ordering Code: Order Number FST3306MTC Package Number MTC08 Package.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
FST3050 Schottky Barrier Rectifier INCHANGE
FST31100 30 AMP SCHOTTKY RECTIFIERS Microsemi Corporation
FST31120 (FST31120 - FST31150) 30 AMP SCHOTTKY RECTIFIERS Microsemi Corporation
FST31130 (FST31120 - FST31150) 30 AMP SCHOTTKY RECTIFIERS Microsemi Corporation
FST31150 (FST31120 - FST31150) 30 AMP SCHOTTKY RECTIFIERS Microsemi Corporation

Other Datasheets by Fairchild (now onsemi)

Part Number Description
FST3306MTC 2-Bit Low Power Bus Switch
FST3345 8-Bit Bus Switch
FST3345MTC 8-Bit Bus Switch
FST3345QSC 8-Bit Bus Switch
FST3345WM 8-Bit Bus Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
FST3306 2-Bit Low Power Bus Switch February 2001 Revised February 2001 FST3306 2-Bit Low Power Bus Switch General Description The FST3306 is a 2-bit ultra high-speed CMOS FET bus switch with TTL-compatible active LOW control inputs. The low on resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 2-bit switch with independent bus enable (BE) controls. When BE is LOW, the switch is ON and Port A is connected to Port B. When BE is HIGH, the switch is OPEN and a high-impedance state exists between the two ports. Control inputs tolerate voltages up to 5.5V independent of VCC. Features s Typical 3Ω switch resistance at 5.