M22520-2-01 Datasheet | HARWIN

.. HAND CRIMP TOOL M22520/2-01 This Hand Crimp Tool has been designed for use with the following Datamate crimp sockets (when used with Positioner T5747): M80-0110001 Large bore crimp socket (22 AWG), Tin shell/Gold clip (used in M80-889XX01 and M80-899XX01) M80-0110005 Large bore crimp socket (22 AWG), Gold shell/Gold clip (used in M80-889XX05 and M80-899XX05) M80-0130001 Small bore crimp socket (24-28 AWG), Tin shell/Gold clip (used in M80-888XX01 and M80-898XX01) M80-0130005 Small bore crimp socket (24-28 AWG), Gold shell/Gold clip (used in M80-888XX05 and M80-898XX05) The following Datamate Power Crimp Sockets can also be crimped (when used with Positioner Z80-058): M80-0550001 Power crimp socket (18-20 AWG), Tin shell/Gold clip (used in M80-716XX01 and M80-719XX01) M80-0550005 Power crimp socket (18-20 AWG), Gold shell/Gold clip (used in M80-716XX05 and M80-719XX05) .. Tel: Fax: E-Mail: IS-01 HARWIN Inc U.S.A. 812 285 0055 812 285 0056 mis@harwin. Issue: 2 Date: 06.09.00 C/Note: 5393 HARWIN plc U.K. 023 9231 4545 023 9231 4590 mis@harwin.co.uk HARWIN pte Singapore 65 779 1304 65 779 3868 mis@harwin..sg Side 1 The following Power Crimp Sockets can also be crimped (when used with Positioner ZK3609-00): K3606-06 Power crimp pin (18 AWG), Tin plated K3607-T6 Power crimp socket (18 AWG), Tin shell/ Tin clip GENERAL INFORMATION The Hand crimp tool M22520/2-01 consists of a basic hand tool, which should be used with a positioner. The contact is correctly crimped when the tool is free to open at the fully closed position, i.e., when the ratchet releases. The tool cannot be opened without pleting the cycle. TOOL PREPARATION 1. 2. 3. 4. 5. 6. Check that the tool is in the open position. Remove the safety clip from the positioner guide (do not discard). Insert the Positioner into the positioner guide and turn it 90° in the direction shown on the tool, until the bayonet pins...