Datasheet4U Logo Datasheet4U.com

HD74ALVCH162830 - 1-bit to 2-bit Address Driver with 3-state Outputs

General Description

This 1-bit to 2-bit address driver is designed for 2.3 V to 3.6 V V CC operation.

To ensure the high impedance state during power up or power down, OE should be tied to V CC through a pullup resistor; the minimum value of the resistor is determined by the current sinking capability of the driver.

Key Features

  • VCC = 2.3 V to 3.6 V.
  • Typical VOL ground bounce < 0.8 V (@VCC = 3.3 V, Ta = 25°C).
  • Typical VOH undershoot > 2.0 V (@VCC = 3.3 V, Ta = 25°C).
  • High output current ±12 mA (@VCC = 3.0 V).
  • Bus hold on data inputs eliminates the need for external pullup / pulldown resistors.
  • All outputs have equivalent 26 Ω series resistors, so no external resistors are required HD74ALVCH162830 Function Table Inputs OE1 L L H H L L H H : High level L : Low level.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
HD74ALVCH162830 1-bit to 2-bit Address Driver Renesas
HD74ALVCH162831 1-bit 4-bit Address Register / Driver Renesas
HD74ALVCH162827 20-bit Buffers / Drivers Renesas
HD74ALVCH162244 16-bit Buffers / Drivers Renesas
HD74ALVCH162270 12-bit to 24-bit Registered Bus Exchanger Renesas

Other Datasheets by Hitachi Semiconductor (now Renesas)

Part Number Description
HD74ALVCH162831 1-bit 4-bit Address Register / Driver with 3-state Outputs
HD74ALVCH162835 18-bit Universal Bus Drivers with 3-state Outputs
HD74ALVCH162836 20-bit Universal Bus Driver with 3-state Outputs
HD74ALVCH162820 3.3-V 10-bit Flip Flops with Dual Outputs and 3-state Outputs
HD74ALVCH162821 3.3-V 20-bit Bus Interface Flip Flops with 3-state Outputs

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
HD74ALVCH162830 1-bit to 2-bit Address Driver with 3-state Outputs ADE-205-197 (Z) Preliminary 1st. Edition November 1997 Description This 1-bit to 2-bit address driver is designed for 2.3 V to 3.6 V V CC operation. To ensure the high impedance state during power up or power down, OE should be tied to V CC through a pullup resistor; the minimum value of the resistor is determined by the current sinking capability of the driver. Active bus hold circuitry is provided to hold unused or floating inputs at a valid logic level. All outputs, which are designed to sink up to 12 mA, include equivalent 26 Ω resistors to reduce overshoot and undreshoot. Features • VCC = 2.3 V to 3.6 V • Typical VOL ground bounce < 0.8 V (@VCC = 3.3 V, Ta = 25°C) • Typical VOH undershoot > 2.0 V (@VCC = 3.