BFH Datasheet | ITT

Features - Meets the requirements of MIL-C-5015. - Solder or laser weld mount. - Square flange mount. Performance Specifications Air Leakage Rate Connector Durability Contact Retention Contact Termination Coupling DWV Flange Type Insulation Resistance Number of Circuits Operating Temperature Service Class Shell Style Wire Acmodation Electrical Service Data Contact Size Current Rating (max.)✧ Contact Resistance (max.) - Locknut mount. - Pin or socket contacts are available in selected layouts. - Resistance to very high pressure differential is achieved using individual glass beads. However, DWV ratings are lower. ≤1 micron ft3/hr max. (1.04 x 10- 5 cm3/s) at one atmosphere pressure differential 100 mating cycles min. 500 psi min., considerably higher with individual glass seals Eyelet; PC Tail; Solder Threaded Dependent upon contact cavity arrangement Circular; Flangeless; Hex; Square 5000 MΩ min. at 500 V dc Up to 75 - 54°C to 150°C (- 65°F to 302°F) for standard finishes Hermetically Sealed Bulkhead Thru-Bulkhead, Jam Nut Mounting Thru-Bulkhead, Square Flange Up to #0 AWG, dependent upon contact cavity arrangement 16 10 A 12.50 mΩ 12 17 A 7.40 mΩ 8 33 A 4.00 mΩ 4 60 A 2.10 mΩ 0 100 A 1.25 mΩ Materials and Finishes Description Shell Insulator Contact O-Ring Material Steel High Grade Plastic Steel Nitrile per AN6227 Finish Clear Chromate over Cadmium# - Clear Chromate over Cadmium# - Please contact your local Cannon representative: .ittcannon./support/Contact Us ✧ This is the maximum current for one single contact. Using MIL-W-5088 and current carried by all contacts within the connector, heat rise can be predicted. The heat rise must not cause the connector temperature range to be exceeded. # Additional finishes for high temperature and special applications are available. Receptacles with a maximum air leakage rate of .01 micron cubic foot per hour are also available. Dimensions are shown in mm (inch) Dimensions subject to change Version 05.01.03 J-01 .ittcanno...