Datasheet4U Logo Datasheet4U.com

M675 - VOLTAGE CONTROLLED SAW OSCILLATOR

General Description

The M675 is a VCSO (Voltage Controlled SAW Oscillator) frequency source for low-jitter clock generation.

An integrated SAW (surface acoustic wave) delay line implements the high-Q VCO (voltage controlled oscillator) function, which results in low output phase noise and very low jitter.

Key Features

  • Integrated SAW device.
  • M675-01 output frequencies from 125 to 175 MHz M675-02 output frequencies from 500 to 700 MHz (Specify center frequency at time of order).
  • Industry-standard Kvco for full compatibility.
  • Low phase jitter 0.2ps rms typical for the M675-02 (50kHz to 80MHz).
  • Differential 3.3V LVPECL output.
  • Single 3.3V power supply.
  • Small 5 x 7.5mm SMT (surface mount) package Table 1: Sample of Available Output Frequencies Note 1: Specify VCSO center frequ.

📥 Download Datasheet

Datasheet Details

Part number M675
Manufacturer Integrated Circuit Systems
File Size 257.22 KB
Description VOLTAGE CONTROLLED SAW OSCILLATOR
Datasheet download datasheet M675 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
M6759 8-bit MTP Micro-controller Acer Laboratories
M67 SIMPLE MELODY GENERATOR Micro Electronics
M67 DOUBLE-BALANCED MIXER Tyco Electronics
M67025E Tolerant High Speed 8 Kb x 16 Dual Port RAM ATMEL Corporation
M67204F (M6720xxF) Rad Tolerant High Speed 16Kx9 Parallel Fifo ATMEL Corporation

Other Datasheets by Integrated Circuit Systems

Part Number Description
M670 VOLTAGE CONTROLLED SAW OSCILLATOR

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Integrated Circuit Systems, Inc. Preliminary Information M675 VOLTAGE CONTROLLED SAW OSCILLATOR PIN ASSIGNMENT (5 x 7.5mm SMT) nFOUT FOUT GND VCC GENERAL DESCRIPTION The M675 is a VCSO (Voltage Controlled SAW Oscillator) frequency source for low-jitter clock generation. An integrated SAW (surface acoustic wave) delay line implements the high-Q VCO (voltage controlled oscillator) function, which results in low output phase noise and very low jitter. The M675-01 is available in a range of center frequencies from 125 to 175 MHz. The M675-02 provides 500 to 700 MHz. Guaranteed minimum pull-range of ±100 ppm meets GbE requirements. (It also fully satisfies ±50 ppm minimum pull-range specification commonly required.) Industry-standard Kvco (VCO Gain) provides full replacement compatibility.