CP82C84A Datasheet PDF - Intersil Corporation CMOS Clock Generator Driver Specs

CP82C84A - CMOS Clock Generator Driver

Datasheet Summary

Description

I ADDRESS ENABLE: AEN is an active LOW signal.

AEN serves to qualify its respective Bus Ready Signal (RDY1 or RDY2).

AEN1 validates RDY1 while AEN2 validates RDY2.

Features

Generates the System Clock For CMOS or NMOS Microprocessors.
Up to 25MHz Operation.
Uses a Parallel Mode Crystal Circuit or External Frequency Source.
Provides Ready Synchronization.
Generates System Reset Output From Schmitt Trigger Input.
TTL Compatible Inputs/Outputs.
Very Low Power Consumption.
Single 5V Power Supply.
Operating Temperature Ranges - C82C84A.
0°C to +70.

Datasheet Details

Part number	CP82C84A
Manufacturer	Intersil Corporation
File Size	274.32 KB
Description	CMOS Clock Generator Driver
Datasheet	CP82C84A Datasheet
Additional preview pages of the CP82C84A datasheet.

📁 Similar Datasheet

CP82C37A - CMOS High Performance Programmable DMA Controller (Harris Corporation)

CP82C37A-12 - CMOS High Performance Programmable DMA Controller (Harris Corporation)

CP82C37A-5 - CMOS High Performance Programmable DMA Controller (Harris Corporation)

CP82C50A-5 - CMOS Serial Controller Interface (Renesas)

CP82C52 - CMOS Serial Controller Interface (Renesas)

CP82C52Z - CMOS Serial Controller Interface (Renesas)

CP82C55A - CMOS Programmable Peripheral Interface (Harris Corporation)

CP82C55A-5 - CMOS Programmable Peripheral Interface (Harris Corporation)

CP8208 - D1 WDR CMOS IMAGE SENSOR (ClairPixel)

CP8210 - 1M WDR CMOS IMAGE SENSOR (ClairPixel)

Full PDF Text Transcription

Click to expand full text

Data Sheet September 9, 2015 82C84A FN2974.4 CMOS Clock Generator Driver The Intersil 82C84A is a high performance CMOS Clock Generator-driver which is designed to service the requirements of both CMOS and NMOS microprocessors such as the 80C86, 80C88, 8086 and the 8088. The chip contains a crystal controlled oscillator, a divide-by-three counter and complete “Ready” synchronization and reset logic. Static CMOS circuit design permits operation with an external frequency source from DC to 25MHz. Crystal controlled operation to 25MHz is guaranteed with the use of a parallel, fundamental mode crystal and two small load capacitors. All inputs (except X1 and RES) are TTL compatible over temperature and voltage ranges.

Published: Mar 23, 2005 |