KKA4605-2 Datasheet | Kodenshi AUK Group

.. TECHNICAL DATA Control IC for Switched Mode Power Supplies using MOS Transistors The IC KKA4605-2 controls the MOS - power transistor and performs all necessary regulation and monitoring function in free running flyback converters. Because of the fact that a wide load range is achieved, this IC is applicable for consumer as well as industrial power supplies. The serial circuit and primary winding of the flyback transformer are connected in series to the input voltage. During the switch - on period of the transistor, energy is stored in the transformer. During the switch - off period the energy is fed to the load via the secondary winding. By varying switch - on time of the Power transistor, the IC controls each portion of energy transferred to the secondary side such that the output voltage remains nearly independent of load variations. The required control information is taken from the input voltage during the switch - on period and from a regulation winding during the switch - off period. A new cycle will start if the transformer has transferred the stored energy pletely into the load. Features : - - - - - - - Fold - back characteristics provides overload protection for external ponents Burst operation under secondary short - circuit condition implemented Protection against open or short of the control loop Switch - off if line voltage is too low (undervoltage switch - off) Line voltage depending pensation of fold - back point Soft start for quiet start - up without noise generated by the transformer Chip - over temperature protection (thermal shutdown) On - chip ringing suppression circuit against parasitic oscillations of the transformer P-DIP-8-1 - In the different voltage ranges the switched - mode Power supply (SMPS) behaves as follow: No load operation. The Power supply is operating in the burst mode at typical 20 to 40 k Hz. The output voltage can be a little bit higher or lower than the nominal value depending on the...