KK74ACT299 Datasheet | Kodenshi AUK Group

features a multiplexed parallel input/output data port to achieve full 8-bit handling in a 20 pin package. Due to the large output drive capability and the 3-state feature , this device is ideally suited for interface with bus lines in a bus-oriented system. Two Mode-Select inputs and two Output Enable inputs are used to choose the mode of operation as listed in the Function Table. Synchronous parallel loading is acplished by taking both Mode Select lines, S1 and S2, high. This places the outputs in the highimpedance state, which permits data applied to the data port to be clocked into the register. Reading out of the register can be acplished when the outputs are enabled. The active-low asynchronous Reset overrides all other inputs. - TTL/NMOS patible Input Levels - Outputs Directly Interface to CMOS, NMOS, and TTL - Operating Voltage Range: 4.5 to 5.5 V - Low Input Current: 1.0 µA; 0.1 µA @ 25°C - Outputs Source/Sink 24 m A ORDERING INFORMATION KK74ACT299N Plastic KK74ACT299DW SOIC TA = -40° to 85° C for all packages PIN ASSIGNMENT LOGIC DIAGRAM PIN 20=VCC PIN 10 = GND .. MAXIMUM RATINGS- Symbol VCC VIN VOUT IIN IOUT ICC PD Tstg TL - Parameter DC Supply Voltage (Referenced to GND) DC Input Voltage (Referenced to GND) DC Output Voltage (Referenced to GND) DC Input Current, per Pin DC Output Sink/Source Current, per Pin DC Supply Current, VCC and GND Pins Power Dissipation in Still Air, Plastic DIP+ SOIC Package+ Storage Temperature Lead Temperature, 1 mm from Case for 10 Seconds (Plastic DIP or SOIC Package) Value -0.5 to +7.0 -0.5 to VCC +0.5 -0.5 to VCC +0.5 ±20 ±50 ±50 750 500 -65 to +150 260 Unit V V V m A m A m A m W °C °C Maximum Ratings are those values beyond which damage to the device may occur. Functional operation should be restricted to the Remended Operating Conditions. +Derating - Plastic DIP: - 10 m W/°C from 65° to 125°C SOIC Package: : - 7 m W/°C from 65° to 125°C REMENDED OPERATING CONDITIONS Symbol VCC VIN, VOUT TJ TA IOH IOL...