LT1510 Datasheet | Linear Technology

LT1510/LT1510-5 Constant-Voltage/ Constant-Current Battery Charger Features s s s s s s s s s Charges Ni Cd, Ni MH and Lithium-Ion Batteries - - Only One 1/10W Resistor Is Needed to Program Charging Current High Efficiency Current Mode PWM with 1.5A Internal Switch and Sense Resistor 3% Typical Charging Current Accuracy Precision 0.5% Voltage Reference for Voltage Mode Charging or Overvoltage Protection Current Sensing Can Be at Either Terminal of the Battery Low Reverse Battery Drain Current: 3µA Charging Current Soft Start Shutdown Control 500k Hz Version Uses Small Inductor plest, most efficient solution to fast-charge modern rechargeable batteries including lithium-ion (Li-Ion), nickelmetal-hydride (Ni MH)- and nickel-cadmium (Ni Cd)- that require constant-current and/or constant-voltage charging. The internal switch is capable of delivering 1.5A DC current (2A peak current). The 0.1Ω onboard current sense resistor makes the charging current programming very simple. One resistor (or a programming current from a DAC) is required to set the full charging current (1.5A) to within 5% accuracy. The LT1510 with 0.5% reference voltage accuracy meets the critical constant-voltage charging requirement for lithium cells. The LT1510 can charge batteries ranging from 2V to 20V. Ground sensing of current is not required and the battery’s negative terminal can be tied directly to ground. A saturating switch running at 200k Hz (500k Hz for LT1510-5) gives high charging efficiency and small inductor size. A blocking diode is not required between the chip and the battery because the chip goes into sleep mode and drains only 3µA when the wall adaptor is unplugged. Soft start and shutdown Features are also provided. The LT1510 is available in a 16-pin fused lead power SO package with a thermal resistance of 50°C/W, an 8-pin SO and a 16-pin PDIP. , LTC and LT are registered trademarks of Linear Technology Corporation. - Ni Cd and Ni MH batteries require charge termination circuitry...