LTC1148 Datasheet | Linear Technology

LTC1148 LTC1148-3.3/LTC1148-5 High Efficiency Synchronous Step-Down Switching Regulators Features s s DESCRIPTIO s s s s s s s s s s Ultrahigh Efficiency: Over 95% Possible Current-Mode Operation for Excellent Line and Load Transient Response High Efficiency Maintained Over Three Decades of Output Current Low 160µA Standby Current at Light Loads Logic Controlled Micropower Shutdown: IQ < 20µA Wide VIN Range: 3.5V- to 20V Short-Circuit Protection Very Low Dropout Operation: 100% Duty Cycle Synchronous FET Switching for High Efficiency Adaptive Nonoverlap Gate Drives Output Can Be Externally Held High in Shutdown Available in 14-Pin Narrow SO Package The LTC®1148 series is a family of synchronous stepdown switching regulator controllers featuring automatic Burst Mode TM operation to maintain high efficiencies at low output currents. These devices drive external plementary power MOSFETs at switching frequencies up to 250k Hz using a constant off-time current-mode architecture providing constant ripple current in the inductor. The operating current level is user-programmable via an external current sense resistor. Wide input supply range allows operation from 3.5V- to 18V (20V maximum). Constant off-time architecture provides low dropout regulation limited by only the RDS(ON) of the external MOSFET and resistance of the inductor and current sense resistor. The LTC1148 series bines synchronous switching for maximum efficiency at high currents with an automatic low current operating mode, called Burst Mode operation, which reduces switching losses. Standby power is reduced to only 2m W at VIN = 10V (at IOUT = 0). Load currents in Burst Mode operation are typically 0m A to 300m A. For operation up to 48V input, see the LTC1149 and LTC1159 data sheets and Application Note 54. , LTC and LT are registered trademarks of Linear Technology Corporation. Burst Mode is a trademark of Linear Technology Corporation. - LTC1148L and LTC1148L-3.3 only. APPLICATI s s s s s...