Datasheet4U Logo Datasheet4U.com

LTC1710 - SMBus Dual Monolithic High Side Switch

General Description

The LTC®1710 SMBus dual switch has two built-in 0.4Ω/ 300mA switches that are controlled by a 2-wire SMBus interface.

Key Features

  • s s s s s s s s s s.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LTC1701B 1MHz Step-Down DC/DC Converters Linear
LTC1706-61 5-Bit VID Voltage Programmer Linear
LTC1706-63 5-Bit VID Voltage Programmer Linear
LTC1730-4 Lithium-Ion Battery Pulse Charger Linear
LTC1730-4.2 Lithium-Ion Battery Pulse Charger Linear

Other Datasheets by Linear Technology (Analog Devices)

Part Number Description
LTC1700 No RSENSE Synchronous Step-Up DC/DC Controller
LTC1701 1MHz Step-Down DC/DC Converters
LTC1702 Dual 550kHz Synchronous 2-Phase Switching Regulator Controller
LTC1703 Dual 550kHz Synchronous 2-Phase Switching Regulator Controller
LTC1704 550kHz Synchronous Switching Regulator Controller Plus Linear Regulator Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
LTC1710 SMBus Dual Monolithic High Side Switch FEATURES s s s s s s s s s s DESCRIPTION The LTC®1710 SMBus dual switch has two built-in 0.4Ω/ 300mA switches that are controlled by a 2-wire SMBus interface. With a low standby current of 14µA (3.3V), the LTC1710 operates over an input voltage range of 2.7V to 5.5V while maintaining the SMBus specified 0.6V VIL and 1.4V VIH input thresholds. Using the 2-wire interface, CLK and DATA, the LTC1710 follows SMBus’s Send Byte Protocol to independently control the two 0.4Ω internal N-channel power switches, which are fully enhanced by onboard charge pumps. The LTC1710 has one three-state programmable address pin that allows three different addresses for a total of six available switches on the same bus.