LT1214 Datasheet | Linear Technology

LT1213/LT1214 28MHz, 12V/µs, Single Supply Dual and Quad Precision Op Amps Features s Slew Rate: 12V/µs Typ s Gain-Bandwidth Product: 28MHz Typ s Fast Settling to 0.01% 2V Step to 200µV: 500ns Typ 10V Step to 1m V: 1.1µs Typ s Excellent DC Precision in All Packages Input Offset Voltage: 275µV Max Input Offset Voltage Drift: 6µV/°C Max Input Offset Current: 40n A Max Input Bias Current: 200n A Max Open-Loop Gain: 1200V/m V Min s Single Supply Operation Input Voltage Range Includes Ground Output Swings to Ground While Sinking Current s Low Input Noise Voltage: 10n V/√Hz Typ s Low Input Noise Current: 0.2p A/√Hz Typ s Specified at 3.3V, 5V and ±15V s Large Output Drive Current: 30m A Min s Low Supply Current per Amplifier: 3.5m A Max s Dual in 8-Pin DIP and SO-8 s Quad in 14-Pin DIP and NARROW SO-16 Note: For applications requiring higher slew rate, see the LT1215/LT1216 data sheet. For lower power and lower slew rate, see the LT1211/LT1212 data sheet. DESCRIPTIO The LT®1213 is a dual, single supply precision op amp with a 28MHz gain-bandwidth product and a 12V/µs slew rate. The LT1214 is a quad version of the same amplifier. The DC precision of the LT1213/LT1214 eliminates trims in most systems while providing high frequency performance not usually found in single supply amplifiers. The LT1213/LT1214 will operate on any supply greater than 2.5V and less than 36V total. These amplifiers are specified at single 3.3V, single 5V and ±15V supplies, and only require 2.7m A of quiescent supply current per amplifier. The inputs can be driven beyond the supplies without damage or phase reversal of the output. The minimum output drive is 30m A, ideal for driving low impedance loads. U APPLICATIO S s 2.5V Full-Scale 12-Bit Systems: VOS ≤ 0.45LSB s 10V Full-Scale 16-Bit Systems: VOS ≤ 1.8LSB s Active Filters s Photodiode Amplifiers s DAC Current-to-Voltage Amplifiers s Battery-Powered Systems , LTC and LT are registered trademarks of Linear Technology Corporation. TYPICAL...