LTC1147-5 Datasheet | Linear Technology

LTC1147-3.3 LTC1147-5/LTC1147L High Efficiency Step-Down Switching Regulator Controllers Features s s s DESCRIPTIO s s s s s s s s Very High Efficiency: Over 95% Possible Wide VIN Range: 3.5V- to 16V Current Mode Operation for Excellent Line and Load Transient Response High Efficiency Maintained Over Three Decades of Output Current Low 160µA Standby Current at Light Loads Logic Controlled Micropower Shutdown: IQ < 20µA Short-Circuit Protection Very Low Dropout Operation: 100% Duty Cycle High Efficiency in a Small Amount of Board Space Output Can Be Externally Held High in Shutdown Available in 8-Pin SO Package The LTC®1147 series are step-down switching regulator controllers featuring automatic Burst Mode TM operation to maintain high efficiencies at low output currents. These devices drive an external P-channel power MOSFET at switching frequencies exceeding 400k Hz using a constant off-time current mode architecture providing constant ripple current in the inductor. The operating current level is user-programmable via an external current sense resistor. Wide input supply range allows operation from 3.5V- to 14V (16V maximum). Constant off-time architecture provides low dropout regulation limited by only the RDS(ON) of the external MOSFET and resistance of the inductor and current sense resistor. The LTC1147 series incorporates automatic power saving Burst Mode operation to reduce switching losses when load currents drop below the level required for continuous operation. Standby power is reduced to only 2m W at VIN = 10V (at IOUT = 0). Load currents in Burst Mode operation are typically 0m A to 300m A. For applications where even higher efficiency is required, refer to the LTC1148 data sheet and Application Note 54. , LTC and LT are registered trademarks of Linear Technology Corporation. Burst Mode is a trademark of Linear Technology Corporation. - LTC1147L and LTC1147L-3.3 only. U APPLICATIO S s s s s s s Notebook and Palmtop puters Portable Instruments...