LTC1159-3.3 Datasheet | Linear Technology

LTC1159 LTC1159-3.3/LTC1159-5 High Efficiency Synchronous Step-Down Switching Regulators Features s Operation from 4V to 40V Input Voltage s Ultrahigh Efficiency: Up to 95% s 20µA Supply Current in Shutdown s High Efficiency Maintained Over Wide Current Range s Current Mode Operation for Excellent Line and Load Transient Response s Very Low Dropout Operation: 100% Duty Cycle s Short-Circuit Protection s Synchronous FET Switching for High Efficiency s Adaptive Non-Overlap Gate Drives s Available in SSOP and SO Packages U APPLICATIO S s Step-Down and Inverting Regulators s Notebook and Palmtop puters s Portable Instruments s Battery-Operated Digital Devices s Industrial Power Distribution s Avionics Systems s Tele Power Supplies DESCRIPTIO The LTC®1159 series is a family of synchronous step-down switching regulator controllers featuring automatic Burst Mode TM operation to maintain high efficiencies at low output currents. These devices drive external plementary power MOSFETs at switching frequencies up to 250k Hz using a constant off-time current-mode architecture. A separate pin and on-board switch allow the MOSFET driver power to be derived from the regulated output voltage providing significant efficiency improvement when operating at high input voltages. The constant off-time current-mode architecture maintains constant ripple current in the inductor and provides excellent line and load transient response. The output current level is user programmable via an external current sense resistor. The LTC1159 automatically switches to power saving Burst Mode operation when load current drops below approximately 15% of maximum current. Standby current is only 300µA while still regulating the output and shutdown current is a low 20µA. , LTC and LT are registered trademarks of Linear Technology Corporation. Burst Mode is a trademark of Linear Technology Corporation. TYPICAL APPLICATIO + 3.3µF 0.15µF VIN CAP P-GATE VCC VCC P-DRIVE EXTVCC LTC1159-5 0V =...