LTC1165 Datasheet | Linear Technology

LTC1163/LTC1165 Triple 1.8V to 6V High-Side MOSFET Drivers Features s s s s s s s s s s DESCRIPTIO Operates from 1.8V to 6V 0.01µA Standby Current 95µA Operating Current per Channel at 3.3V Fully Enhances N-Channel Switches No External Charge Pump ponents Built-In Gate Voltage Clamps Easily Protected Against Supply Transients Controlled Switching ON and OFF Times patible with 5V, 3V and Sub-3V Logic Families Available in 8-Pin SOIC The LTC1163/LTC1165 triple low voltage MOSFET drivers make it possible to switch supply or ground referenced loads through inexpensive, low RDS(ON) N-channel switches from as little as a 1.8V supply. The LTC1165 has inverting inputs and makes it possible to directly replace P-channel MOSFET switches while maintaining system drive polarity. The LTC1163 has noninverting inputs. Micropower operation, with 0.01µA standby current and 95µA operating current, coupled with a power supply range of 1.8V to 6V, make the LTC1163/LTC1165 ideally suited for 2- to 4-cell battery-powered applications. The LTC1163/LTC1165 are also well suited for sub-3V, 3.3V and 5V nominal supply applications. The LTC1163/LTC1165 internal charge pumps boost the gate voltage 8V above a 3.3V rail, fully enhancing inexpensive N-channels for high- or low-side switch applications. The LTC1163/LTC1165 are available in both an 8-pin DIP and an 8-pin SOIC. APPLICATI s s s s s s s s PCMCIA Card 3.3V/5V Switch 2-Cell High-Side Load Switching Boost Regulator Shutdown to Zero Standby Current Replacing P-Channel Switches Notebook puter Power Management Palmtop puter Power Management Portable Medical Equipment Mixed 3.3V and 5V Supply Switching TYPICAL APPLICATI (1.8V TO 3V) 2-Cell Triple High-Side Switch + 2-CELL BATTERY PACK + 10µF GATE OUTPUT VOLTAGE (V) RFD14N05LSM RFD14N05LSM RFD14N05LSM 14 12 10 8 6 4 2 IN1 CONTROL LOGIC OR µP OUT1 IN2 LTC1163 OUT2 LTC1165 IN3 OUT3 GND 2-CELL LOAD 2-CELL LOAD 2-CELL LOAD LTC1163 HAS NONINVERTING INPUTS...