LTC1705 Datasheet | Linear Technology

.. Features s s s s s LTC1705 Dual 550k Hz Synchronous Switching Regulator Controller with 5-Bit VID and 150m A LDO DESCRIPTIO The LTC®1705 is a plete power supply controller for Intel Mobile Pentium processors. It includes two switching regulator controllers, each designed to drive a pair of N-channel MOSFETs in a voltage mode feedback, synchronous buck configuration, to provide the core and I/O supplies. The core controller includes a 5-bit DAC that conforms to the Intel Mobile VID specification. The IC also includes a low dropout linear regulator (LDO) that delivers up to 150m A of output current to provide the CLK supply. The LTC1705 uses a constant-frequency 550k Hz PWM architecture, minimizing external ponent size and cost, as well as optimizing load transient performance. It provides better than 1.25% DC accuracy at its core output, and 2% at I/0 and CLK outputs. The high performance feedback loops allow the circuit to keep total output regulation within ±5% under all transient conditions. An open-drain PGOOD flag indicates that all three outputs are within ±10% of their regulated values. A shutdown circuit disables all three outputs if the RUN/SS pin is pulled to ground. In this mode, the LTC1705 supply current drops to below 100µA. , LTC and LT are registered trademarks of Linear Technology Corporation. Pentium is a registered trademark of Intel Corporation. s s s s s s s Three Regulated Outputs: Core, I/O and CLK in One Package Integrated Intel Mobile 5-Bit VID DAC No External Current Sense Resistors All N-Channel External MOSFET Architecture 550k Hz Switching Frequency Minimizes External ponent Size and Cost Integrated 150m A LDO Linear Regulator Excellent DC Accuracy: 1.25% for Core, 2% for I/O and CLK Supplies PGOOD Flag Monitors All Three Outputs High Efficiency Over Wide Load Current Range Low Shutdown Current: < 100µA Switchers Run Out-of-Phase to Minimize CIN Small 28-Pin Narrow SSOP Package U APPLICATIO S s s s plete...