LTM4608A Datasheet | Linear Technology

.. LTM4608A Low VIN, 8A DC/DC µModule with Tracking, Margining, and Frequency Synchronization DESCRIPTION The LTM®4608A is a plete 8A switch mode DC/DC power supply with ±1.75% total output voltage error. Included in the package are the switching controller, power FETs, inductor and all support ponents. Operating over an input voltage range of 2.7V to 5.5V, the LTM4608A supports an output voltage range of 0.6V to 5V, set by a single external resistor. This high efficiency design delivers up to 8A continuous current (10A peak). Only bulk input and output capacitors are needed to plete the design. The low profile package (2.8mm) enables utilization of unused space on the back side of PC boards for high density point-of-load regulation. The 0.630mm LGA pads with 1.27mm pitch simplify PCB layout by providing standard trace routing and via placement. The high switching frequency and current mode architecture enable a very fast transient response to line and load changes without sacrificing stability. The device supports frequency synchronization, programmable multiphase and/or spread spectrum operation, output voltage tracking for supply rail sequencing and voltage margining. Fault protection Features include overvoltage protection, overcurrent protection and thermal shutdown. The power module is offered in a pact and thermally enhanced 15mm × 9mm × 2.8mm surface mount LGA package. The LTM4608A is Pb-free and Ro HS pliant. Features - - - - - - - - - - - - - - - - - plete Standalone Power Supply ±1.75% Total DC Output Error (- 55°C to 125°C) 2.7V to 5.5V Input Voltage Range 8A DC, 10A Peak Output Current 0.6V Up to 5V Output Output Voltage Tracking and Margining Power Good Tracks Margining Multiphase Operation Parallel Current Sharing Onboard Frequency Synchronization Spread Spectrum Frequency Modulation Overcurrent/Thermal Shutdown Protection Current Mode Control/Fast Transient Response Selectable Burst Mode® Operation Up to 95%...