RH1086M Datasheet | Linear Technology

RH1086M 0.5A and 1.5A Low Dropout Positive Adjustable Regulators DESCRIPTIO ABSOLUTE AXI U RATI GS PRECONDITIONI G 100% Thermal Limit Burn-In The RH1086M is pin patible with older 3-terminal regulators. A 10µF output capacitor is required on this new device. However, this is usually included in most regulator designs. The wafer lots are processed to Linear Technology Corporation’s in-house Class S flow-to-yield circuits usable in stringent military applications. , LTC and LT are registered trademarks of Linear Technology Corporation. BUR -I CIRCUIT RH1086M 15V IN ADJ OUT 150Ω - 15V CAPACITOR(S) NOT SHOWN RH1086 BI U W U PACKAGE I FOR ATIO BOTTOM VIEW VIN 2 CASE IS OUTPUT 1 ADJ K PACKAGE 2-LEAD TO-3 METAL CAN BOTTOM VIEW ADJ 2 INPUT 1 3 OUTPUT (CASE) H PACKAGE 3-LEAD TO-39 METAL CAN Note: For ordering information contact LTC. The RH1086M positive adjustable regulator is designed to provide 0.5A for the H package and 1.5A for the K package with higher efficiency than currently available devices. All internal circuitry is designed to operate down to 1V inputto-output differential and the dropout voltage is fully specified as a function of load current. Dropout is guaranteed at a maximum of 1.5V at maximum output current, decreasing at lower load currents. On-chip trimming adjusts the output voltage to 1%. Current limit is also trimmed, minimizing the stress on both the regulator and power source circuitry under overload conditions. Power Dissipation.............................. Internally Limited Input-to-Output Voltage Differential ......................... 25V Operating Junction Temperature Range Control Section.............................. - 55°C to 150°C Power Transistor ............................ - 55°C to 200°C Storage Temperature Range .................. - 65°C to 150°C Lead Temperature (Soldering, 10 sec).................. 300°C RH1086M TABLE 1: ELECTRICAL CHARACTERISTICS PARAMETER Reference Voltage CONDITIONS...