Datasheet4U Logo Datasheet4U.com

IS32LT3954 - CONSTANT-CURRENT 3-AMPERE PWM DIMMABLE BUCK REGULATOR LED DRIVER

General Description

The IS32LT3954 is a DC-to-DC switching converter that integrates an N-channel MOSFET to operate in a buck configuration.

The device can operate from a wide input voltage between 4.5V and 38V and provides a constant current of up to 3A for driving a single LED or multiple series connected LEDs.

Key Features

  • Wide input voltage supply from 4.5V to 38V - Withstand 40V load dump.
  • True average output current control.
  • 3A maximum output over operating temperature range.
  • Cycle-by-cycle current limit.
  • Integrated high-side MOSFET switch.
  • Dimming via direct logic input or power supply voltage.
  • Internal control loop compensation.
  • Under-voltage lockout (UVLO) and thermal shutdown protection.
  • 2μA low power shutdown.
  • Spread spectrum to optimize EMI.
  • Robust f.

📥 Download Datasheet

Datasheet Details

Part number IS32LT3954
Manufacturer Lumissil
File Size 778.91 KB
Description CONSTANT-CURRENT 3-AMPERE PWM DIMMABLE BUCK REGULATOR LED DRIVER
Datasheet download datasheet IS32LT3954 Datasheet

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
IS32LT3954 CONSTANT-CURRENT 3-AMPERE PWM DIMMABLE BUCK REGULATOR LED DRIVER WITH OUTPUT FAULT REPORTING August 2019 GENERAL DESCRIPTION The IS32LT3954 is a DC-to-DC switching converter that integrates an N-channel MOSFET to operate in a buck configuration. The device can operate from a wide input voltage between 4.5V and 38V and provides a constant current of up to 3A for driving a single LED or multiple series connected LEDs. The external resistor, RISET, is used to set a constant LED output current, while allowing the output voltage to be automatically adjusted for a variety of LED configurations. The IS32LT3954 operates in a fixed frequency mode during switching. There is an external resistor connected between the VCC and TON pins used to configure the on-time (switching frequency).