MD-179 Datasheet | MACOM Technology Solutions

Features n Intermodulation Ratio is Insensitive to Port Mismatches n VSWR: <2.0:1 Typical Midband n Isolation: 35 d B Typical Midband n Impedance: 50 Ohms Nominal n Maximum Input Power: 350 m W Max @ 25°C, Derated to 85°C @ 3.2 m W/°C n LO Power: +24 d Bm Max. n MIL-STD-883 Screening Available Description The unique design of the termination insensitive mixer (TIM) enables it to apply high reverse voltage to diodes during their “off” phase, in the LO cycle. This allows for higher power level performance with minimum distortion. In addition the TIM has internal loads that provide a good match and also absorb mixer generated LO frequency terms. bined, these features give the mixer its insensitivity to external mismatches, plus superior VSWR. FP-2 (MD-179) C-7 (MDC-179) Rev. V3 Pin Configuration (MD-179) Pin No. 1 2 3 4 Function GND GND GND IF Pin No. 5 6 7 8 Function LO GND GND RF M/A- Technology Solutions Inc. (MA) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit .ma. for additional data sheets and product information. For further information and support please visit: https://.ma./support MD- / MDC-179 Termination Insensitive Mixer, 1 - 4000 MHz Electrical Specifications1: TA = -55°C to +85°C Parameter Test Conditions Frequency Units Min Typ Frequency Range Conversion Loss 2,3 RF, LO Ports IF Port Isolation LO to RF LO to IF RF to IF RF Input SSB Noise Figure Typical Two-Tone IM Ratio 1 d B pression 1 d B Desensitization Within 1 d B of Conversion Loss Max with a - 10 d Bm input, each tone 60 MHz IF 3rd Order Intermodulation Ratio Degradation @ IF VSWR...