Datasheet4U Logo Datasheet4U.com

MP5000A - 5A Programmable Current Limit Switch

General Description

The MP5000A is a protection device designed to protect circuitry on the output (source) from transients on input (VCC).

It also protects VCC from undesired shorts and transients coming from the source.

At start up, inrush current is limited by limiting the slew rate at the source.

Key Features

  • Integrated 40mΩ Power FET.
  • Enable/Fault Pin.
  • Adjustable Slew Rate for Output Voltage.
  • Adjustable Current Limit: 1-5A.
  • Thermal Protection.
  • Over Voltage Limit.
  • Low Inrush Current.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MP5005 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5005 PRESS-FIT MOTOLOLA DIODES Shunye
MP5005W Single Phase Bridge Rectifier MCC
MP5006 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5007 50 Amp Single Phase Bridge Rectifier Micro Commercial Components

Other Datasheets by Monolithic Power Systems

Part Number Description
MP5000ADQ 5A Programmable Current Limit Switch
MP5000 5A Programmable Current Limit Switch
MP5000DQ 5A Programmable Current Limit Switch
MP5000S 5A Programmable Current Limit Switch
MP5000SDQ 5A Programmable Current Limit Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
The Future of Analog IC Technology MP5000A 12V, 5A Programmable Current Limit Switch DESCRIPTION The MP5000A is a protection device designed to protect circuitry on the output (source) from transients on input (VCC). It also protects VCC from undesired shorts and transients coming from the source. At start up, inrush current is limited by limiting the slew rate at the source. The slew rate is controlled by a small capacitor at the dv/dt pin. The dv/dt pin has an internal circuit that allows the customer to float this pin (no connect) and still receive 0.9ms ramp time at the source. The maximum load at the output (source) is current limited. This is accomplished by utilizing a sense FET topology.