Description
Pin 1-BW-
Leave open or hold low for serial output on the TX output.
When BW pin is held high the TX output sends a pulse (instead of serial data), suitable for low noise chaining.
Pin 2-PW- This pin outputs a pulse width representation of range.
Features
- Continuously variable gain for control and side lobe suppression.
- Object detection to zero range objects.
- 2.5V to 5.5V supply with 2mA
typical current draw.
- Readings can occur up to every
50mS, (20-Hz rate).
- Free run operation can continually
measure and output range information.
- Triggered operation provides the range reading as desired.
- Interfaces are active simultaneously.
- Serial, 0 to Vcc, 9600 Baud, 81N.
- Analog, (Vcc/512) / inch.
- Pulse width.
MB1040 Datasheet
