Datasheet4U Logo Datasheet4U.com

MAX3786 - 1.5Gbps Serial ATA-Compatible Mux/Buffer

General Description

The MAX3786 is an AC-coupled, serial-ATA (SATA)compatible, 1.5Gbps multiplexer/buffer (mux/buffer) IC that provides the capability to switch a single serial data signal between two redundant I/O channels.

Key Features

  • < 50psP-P Total Residual Jitter (20in FR-4, EQ and PE On).
  • Supports SATA OOB Signaling.
  • Loopback of Nonselected Channel.
  • Receive Equalization and Transmit Preemphasis on Controller-Side I/O Channels.
  • 0°C to +85°C Operation.
  • 32-Pin, 5mm ✕ 5mm Thin QFN Package.
  • +3.3V Power Supply MAX3786 Ordering Information PART MAX3786UTJ MAX3786UTJ+ TEMP RANGE PIN-.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX378 High-Voltage / Fault-Protected Analog Multiplexers Maxim
MAX3785 6.25Gbps / 1.8V PC Board Equalizer Maxim
max3701 2x Blue Laser Driver with Sample and Hold Maxim
MAX3735 2.7Gbps / Low-Power SFP Laser Drivers Maxim
MAX3735A Low-Power SFP Laser Driver Maxim Integrated

Other Datasheets by Maxim Integrated (now Analog Devices)

Part Number Description
MAX3736 SFP Laser Driver
MAX3738 155Mbps to 4.25Gbps SFF/SFP Laser Driver
MAX3740A SFP VCSEL Driver
MAX3744 (MAX3744 / MAX3745) SFP Transimpedance Amplifiers
MAX3745 (MAX3744 / MAX3745) SFP Transimpedance Amplifiers

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com 19-2727; Rev 2; 6/04 KIT ATION EVALU E L B AVAILA 1.5Gbps Serial ATA-Compatible Mux/Buffer with Loopback and Equalization General Description The MAX3786 is an AC-coupled, serial-ATA (SATA)compatible, 1.5Gbps multiplexer/buffer (mux/buffer) IC that provides the capability to switch a single serial data signal between two redundant I/O channels. SATA out-of-band (OOB) signaling is supported using loss-of-signal (LOS) detect on all three inputs and shutdown on the corresponding outputs. The high-speed inputs and outputs are all internally terminated, compatible with 100Ω differential systems, and must be AC-coupled to the controller IC and SATA-compatible disk drive.