MAX6683 Datasheet | Maxim Integrated

.Data Sheet.co.kr 19-2226; Rev 1; 7/04 KIT ATION EVALU E L B AVAILA Temperature Sensor and System Monitor in a 10-Pin µMAX General Description Features - Monitors Local Temperature - Monitors Three External Voltages (1.8V, 2.5V, 5V Nominal) - Monitors VCC (3.3V Nominal) - User-Programmable Voltage and Temperature Thresholds - Alert Function with Ability to Respond to SMB Alert Response Address - +2.7V to +5.5V Supply Range - -40°C to +125°C Temperature Range - 60Hz or 50Hz Line-Frequency Rejection - Tiny 10-Pin µMAX Package - MAX6683EVKIT Available The MAX6683 system supervisor monitors multiple power-supply voltages, including its own, and also Features an on-board temperature sensor. The MAX6683 converts voltages to an 8-bit code and temperatures to an 11-bit (10-bit-plus-sign) code using an analog-todigital converter (ADC). A multiplexer automatically sequences through the voltage and temperature measurements. The digitized signals are then stored in registers and pared to the over/underthreshold limits programmed over the SMBus™/I 2C™-patible 2wire serial interface. When a temperature measurement exceeds the programmed threshold, or when an input voltage falls outside the programmed voltage limits, the MAX6683 generates a latched interrupt output ALERT . Three interrupt modes are available for temperature excursions. These are default mode, one-time interrupt mode, and parator mode. The ALERT output is cleared, except for temperature interrupts generated in parator mode, by reading the Interrupt Status register (Table 5). The ALERT output can also be masked by writing to the appropriate bits in the Interrupt Mask register (Table 6) or by setting bit 1 of the Configuration register (Table 4) to zero. The MAX6683 SMBus/I2Cpatible interface also responds to the SMB alert response address. Ordering Information PART MAX6683AUB TEMP RANGE -40°C to +125°C PIN-PACKAGE 10 µMAX Applications Workstations Servers Networking Telemunications...