Datasheet4U Logo Datasheet4U.com

MAX2650 - +5V Low-Noise Amplifier

General Description

The MAX2650 is a low-noise amplifier for use from DC to microwave frequencies.

Operating from a single +5V supply, it has a flat gain response to 900MHz.

The MAX2650’s low noise figure and high drive capability make it ideal for a variety of transmit, receive, and buffer applications.

Key Features

  • o Internally Biased o High Gain: 18.3dB at 900MHz o 3.9dB Noise Figure o Single +4.5V to +5.5V Operation o -1dBm Output 1dB Compression Power o Low-Cost Silicon Bipolar Design o Ultra-Small SOT143 Package ______________Ordering Information PART MAX2650EUS-T TEMP RANGE -40°C to +85°C PIN-.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX2655 1575MHz/1900MHz Variable-IP3 Low-Noise Amplifiers Maxim Integrated
MAX2656 1575MHz/1900MHz Variable-IP3 Low-Noise Amplifiers Maxim Integrated
MAX2657 (MAX2657 / MAX2658) GPS/GNSS Low-Noise Amplifiers Maxim Integrated Products
MAX2658 (MAX2657 / MAX2658) GPS/GNSS Low-Noise Amplifiers Maxim Integrated Products
MAX2659 GPS/GNSS Low-Noise Amplifier Maxim Integrated

Other Datasheets by Maxim Integrated (now Analog Devices)

Part Number Description
MAX265 Pin and Resistor Programmed Universal Active Filters
MAX2651 Low-Noise Amplifiers
MAX2652 Low-Noise Amplifiers
MAX2653 Low-Noise Amplifiers
MAX2654 1575MHz/1900MHz Variable-IP3 Low-Noise Amplifiers

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MAX2650 19-1135; Rev 1; 8/03 EVAALVUAAILTAIOBNLEKIT DC-to-Microwave, +5V Low-Noise Amplifier _______________General Description The MAX2650 is a low-noise amplifier for use from DC to microwave frequencies. Operating from a single +5V supply, it has a flat gain response to 900MHz. The MAX2650’s low noise figure and high drive capability make it ideal for a variety of transmit, receive, and buffer applications. The device is internally biased, eliminating the need for external bias resistors or inductors. In a typical application, the only external components needed are input and output blocking capacitors and a VCC bypass capacitor. The MAX2650 comes in a 4-pin SOT143 package, requiring minimal board space.