MIC58P01 Datasheet | Micrel Semiconductor

Micrel 8-Bit Parallel-Input Protected Latched Driver General Description The MIC58P01 parallel-input latched driver is a high-voltage (80V), high-current (500m A) integrated circuit prised of eight CMOS data latches, a bipolar Darlington transistor driver for each latch, and CMOS control circuitry for the mon CLEAR, STROBE, and OUTPUT ENABLE functions. Similar to the MIC5801, additional protection circuitry supplied on this device includes thermal shutdown, under voltage lockout (UVLO), and overcurrent shutdown. The bipolar/CMOS bination provides an extremely lowpower latch with maximum interface flexibility. The MIC58P01 has open-collector outputs capable of sinking 500 m A and integral diodes for inductive load transient suppression with a minimum output breakdown voltage rating of 80V (50V sustaining). The drivers may be paralleled for higher load current capability. With a 5V logic supply, the MIC58P01 will typically operate at better than 5MHz. With a 12V logic supply, significantly higher speeds are obtained. The CMOS inputs are patible with standard CMOS, PMOS, and NMOS circuits. TTL circuits may require pull-up resistors. Each of these eight outputs has an independent overcurrent shutdown of 500m A. Upon current shutdown, the affected channel will turn OFF until VDD is cycled or the ENABLE/ RESET pin is pulsed high. Current pulses less than 2µs will not activate current shutdown. Temperatures above 165°C will shut down all outputs. The UVLO circuit disables the outputs at low VDD; hysteresis of 0.5V is provided. Features - - - - - - - - - 4.4MHz Minimum Data Input Rate High-Voltage, High-Current Outputs Per-Output Overcurrent Shutdown (500m A typical) Under Voltage Lockout Thermal Shutdown Output Transient Protection Diodes CMOS, PMOS, NMOS, and TTL patible Inputs Internal Pull-Down Resistors Low-Power CMOS Latches Ordering Information Part Number MIC58P01BN MIC58P01BV MIC58P01BWM Temperature Range - 40°C to +85°C - 40°C to...