PIC24FJ1024GA610 Datasheet | Microchip Technology

Features - USB v2.0 On-The-Go (OTG) pliant - Dual Role Capable - Can Act as Either Host or Peripheral - Low-Speed (1.5 Mb/s) and Full-Speed (12 Mb/s) USB Operation in Host mode - Full-Speed USB Operation in Device mode - High-Precision PLL for USB - USB Device mode Operation from FRC Oscillator - No Crystal Oscillator Required - Supports up to 32 Endpoints (16 bidirectional): - USB module can use any RAM location on the device as USB endpoint buffers - On-Chip USB Transceiver with Interface for Off-Chip USB Transceiver - Supports Control, Interrupt, Isochronous and Bulk Transfers - On-Chip Pull-up and Pull-Down Resistors Analog Features - 10/12-Bit, up to 24-Channel Analog-to-Digital (A/D) Converter: - 12-bit conversion rate of 200 ksps - Auto-scan and threshold pare features - Conversion available during Sleep - Three Rail-to-Rail, Enhanced Analog parators with Programmable Input/Output Configuration - Charge Time Measurement Unit (CTMU): - Used for capacitive touch sensing, up to 24 channels - Time measurement down to 100 ps resolution Low-Power Features - Sleep and Idle modes Selectively Shut Down Peripherals and/or Core for Substantial Power Reduction and Fast Wake-up - Doze mode Allows CPU to Run at a Lower Clock Speed than Peripherals - Alternate Clock modes Allow On-the-Fly Switching to a Lower Clock Speed for Selective Power Reduction - Wide Range Digitally Controlled Oscillator (DCO) for Fast Start-up and Low-Power Operation Special Microcontroller Features - Large, Dual Partition Flash Program Array: - Capable of holding two independent software applications, including bootloader - Permits simultaneous programming of one partition while executing application code from the other - Allows run-time switching between Active Partitions - 10,000 Erase/Write Cycle Endurance, Typical - Data Retention: 20 Years Minimum - Self-Programmable under Software Control - Supply Voltage Range of 2.0V to 3.6V - Operating Ambient Temperature from -40°C to +85°C for...