USB3300 Datasheet | Microchip Technology

Features - USB-IF Hi-Speed certified to the Universal Serial Bus Specification Rev 2.0 - Interface pliant with the ULPI Specification revision 1.1 in 8-bit mode - Industry standard UTMI+ Low Pin Interface (ULPI) Converts 54 UTMI+ signals into a standard 12 pin Link controller interface - 54.7m A Unconfigured Current (typical) - ideal for bus powered applications - 83u A suspend current (typical) - ideal for battery powered applications - Latch-Up performance exceeds 150 m A per EIA/ JESD 78, Class II - ESD protection levels of ±8k V HBM without external protection devices - Integrated protection to withstand IEC61000-4-2 ESD tests (±8k V contact and ±15k V air) per 3rd party test facility - Supports FS pre-amble for FS hubs with a LS device attached (UTMI+ Level 3) - Supports HS SOF and LS keep-alive pulse - Includes full support for the optional On-The-Go (OTG) protocol detailed in the On-The-Go Supplement Revision 1.0a specification - Supports the OTG Host Negotiation Protocol (HNP) and Session Request Protocol (SRP) - Allows host to turn VBUS off to conserve battery power in OTG applications - Supports OTG monitoring of VBUS levels with internal parators. Includes support for an external VBUS or fault monitor. - Low Latency Hi-Speed Receiver (43 Hi-Speed clocks Max) allows use of legacy UTMI Links with a ULPI wrapper - Integrated Pull-up resistor on STP for interface protection allows a reliable Link/PHY start-up with slow Links (software configured for low power) - Internal 1.8 volt regulators allow operation from a single 3.3 volt supply - Internal short circuit protection of ID, DP and DM lines to VBUS or ground - Integrated 24MHz Crystal Oscillator supports either crystal operation or 24MHz external clock input - Internal PLL for 480MHz Hi-Speed USB operation - Industrial Operating Temperature -40°C to +85°C - 32 pin, QFN Ro HS pliant package (5 x 5 x 0.90 mm height) Applications The USB3300 is the ideal panion to any ASIC, So C or FPGA solution designed with a...